Email us

FAQ
Virtual Campus

Practical Training

Practical Training MPY 315/415

" There will be two information sessions each semester to answer students questions and clarifications about these two modules. The detailed information regarding these sessions will be communicated through email, please check your emails and do not ignore it. Information regarding practical training should be the concern of all students".

Information

Mechanical engineering students must gain six (6) weeks of industrial experience at the end of their 2nd and 3rd years of study. The aim is to develop an insight in the practical application of engineering science in industry and the related human relationships and safety aspects. The Engineering Council of South Africa requires this type of experience in the training of engineering students.

The following documents can assist the student in the preparation for MPY:

Special Concession Regarding MPY 315 and MPY 415 

(University admin,s answer to " Does students have to register or deregister again for MPY if they have not submitted their reports? And do they have to pay again if they re-register the module?" )

We allow students to register for MPY 315/415 once,  the reasons for this is if students are registered for MPY more than once our credit total for the degree (when the degree is completed) will exceed the full degree credits. We have in the the past allow student to be registered for MPY 315/415 in one year and only handing in the report early the following year, we as admin read in the students mark as if he/she completed this module in the year he/she was registered for the said module This, however, is not a set regulation but rather a special concession. 

 

Important Announcement: MPY 315 & MPY 415 Submission (Second Semester)

Please be advised that MPY 315 and MPY 415 submissions (Second semester) will open on Tuesday, 28th of August at 09:00 and will end on Friday, 31st of August at 15:30.

Please note the hand-in times and venue below: 

Venue: Mrs. Karabo Kunene’s Office, Engineering Building III, Room 6-65

Times:

09:00 – 10:45 on 28th, 29th, 30th, and 31st of August 2018.

14:00 – 15:30 on 31st of August 2018.

No reports will be accepted after the deadline (Friday 31st of August at 15:30).

Share this page
Last edited by Barbara HuyssenEdit