Programme: MIntArch (Professional)

Kindly take note of the disclaimer regarding qualifications and degree names.
Code Faculty
12252028 Faculty of Engineering, Built Environment and Information Technology
Credits Duration
Minimum duration of study: 1 year Total credits: 180
Prof BP Jekot
[email protected]
+27 (0)124204052

Programme information

The Master of Interior Architecture (Professional) is done by coursework, a design investigation mini-dissertation and design project and discourse.

Refer to G Regulations G.30 to G.40 and G.50 to G.54.

Admission requirements

Candidates for the degree programme Master of Interior Architecture (Professional):

(i)  must be a graduate with a BIntHons degree or an equivalent university degree;


(ii)  must have an appropriate recognised tertiary qualification at honours degree level;


(iii)  must have a qualification deemed adequate by the head of department in consultation with the Dean and obtain (where necessary) the approval of Senate and comply with any other prescribed requirements.

Candidates mentioned in (ii) and (iii) above may at the discretion of the Head of Department be required to be evaluated in prerequisite fields of knowledge and/or register for additional modules for non-degree purposes.

Candidates mentioned in (i) (ii) and (iii) above:

(a)   should preferably have had practical experience and/or have done and recorded an extended study excursion;

(b)  are interviewed for selection;

(c) must present a portfolio and/or design journal which demonstrates the requisite level of proficiency and competency and is considered a record of their experience within the discipline;

(d) are selected on merit.

Note: A limited number of candidates are admitted to this programme.


Other programme-specific information

Design topic

The topic of the final design project (DIT 803 & DPD 803) must be approved by the Head of Department.

Awarding of degree

The degree is awarded to those students having obtained the prescribed credits. Those students admitted with conditions must comply with all of these before all the 700 series module credits and the degree are awarded.

Examinations and pass requirements

The minimum pass mark is 50%. A minimum of 40% is required in the examination, with a minimum final mark of 50% to pass. If a module is not evaluated by examination, a minimum coursework mark of 50% is required.

If the module is not evaluated by coursework, a minimum examination mark of 50% is required.

Research information

G Regulation G.39.12 applies with regard to the required publication.

Pass with distinction

The degree is conferred with distinction on those students registering for the first time and obtaining a distinction (75%) simultaneously for both the Design investigation mini-dissertation (DIT 803) and the Design project and discourse (DPD 803) with the proviso that the degree is completed within the minimum prescribed time and all other final-year modules are passed on first registration.

The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2024. All rights reserved.

COVID-19 Corona Virus South African Resource Portal

To contact the University during the COVID-19 lockdown, please send an email to [email protected]

FAQ's Email Us Virtual Campus Share Cookie Preferences