Yearbooks

Fabrication engineering 700


 
Module code NFE 700
Qualification Postgraduate
Faculty Faculty of Engineering, Built Environment and Information Technology
Module content

This module looks at quality assurance and control in welded fabrication and manufacture, and introduces various standards and codes of manufacture used in the welding industry. Measurement, control and recording in welding, the principle of fitness for purpose, as well as health and safety issues are addressed. Control of residual stresses and distortion during welding, non-destructive testing, repair welding, and the economics of welding are considered. This module also examines plant facilities, welding jigs and fixtures. Special emphasis is placed on the design and implementation of welding procedure specifications, procedure qualification records and quality control plans. A number of case studies are examined.

Module credits 30.00
Prerequisites No prerequisites.
Contact time 48 contact hours per semester
Language of tuition Module is presented in English
Department Materials Science and Metallurgical Engineering
Period of presentation Semester 1 or Semester 2

The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of each student to familiarise himself or herself well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2019. All rights reserved.

FAQ's Email Us Virtual Campus Share