Yearbooks

Engineering graphics and design 340


 
Module code JTT 340
Qualification Undergraduate
Faculty Faculty of Education
Module content

This module equips students to understand and teach Engineering graphics and design in the FET-Phase. The focus is on  free hand drawing and CAD- drawing techniques contextualised for the Department of Education's curriculum requirements for advanced Mechanical drawing techniques and application. Primary and secondary manufacturing processes. Evaluation of drawings and error detection. Practical application of techniques.

Module credits 20.00
Prerequisites JTT 240
Contact time 2 practicals per week, 2 lectures per week
Language of tuition Afrikaans and English is used in one class
Academic organisation Science, Maths + Techno Ed
Period of presentation Semester 2

The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2024. All rights reserved.

COVID-19 Corona Virus South African Resource Portal

To contact the University during the COVID-19 lockdown, please send an email to [email protected]

FAQ's Email Us Virtual Campus Share Cookie Preferences