Yearbooks

Programme: BEngHons Microelectronic Engineering

Kindly take note of the disclaimer regarding qualifications and degree names.
Code Faculty
12240192 Faculty of Engineering, Built Environment and Information Technology
Credits Duration NQF level
Minimum duration of study: 1 year Total credits: 128 NQF level:  08

Programme information

The curriculum is determined in consultation with the relevant heads of departments. A student is required to pass modules to the value of at least 128 credits.

The degree is awarded on the basis of examinations only.

Admission requirements

  • A BEng degree awarded by the University of Pretoria (or equivalent); or a four-year bachelor’s degree in engineering that ECSA regards as acceptable for registration as a candidate engineer and for eventual registration as a professional engineer.
  • The departmental Postgraduate Committee reserves the right to make a thorough assessment of the applicant's academic transcript and CV, and to decide if the applicant is suitable for postgraduate studies. This assessment may include an oral or written entrance examination.

Other programme-specific information

Students may take modules to the value of 32 credits from other fields of specialisation or from other departments, with approval of the Coordinator: Postgraduate Studies.

Examinations and pass requirements

  1. The examination in each module for which a student is registered, takes place during the normal examination period after the conclusion of lectures (i.e. October/November or May/June).
  2. A student registered for the honours degree must complete his or her studies within two years (full-time), or within three years (part-time) after first registration for the degree: Provided that the Dean, on recommendation of the relevant head of department, may approve a stipulated limited extension of this period.
  3. A student must obtain at least 50% in an examination for each module where no semester or year mark is required. A module may only be repeated once.
  4. In modules where semester or year marks are awarded, a minimum examination mark of 40% and a final mark of 50% is required.
  5. No supplementary or special examinations are granted at postgraduate level.

Pass with distinction

A student passes with distinction if he or she obtains a weighted average of at least 75% in the first 128 credits for which he or she has registered (excluding modules which were discontinued timeously). The degree is not awarded with distinction if a student fails any one module (excluding modules which were discontinued timeously).

Minimum credits: 128

EIN 732 is a compulsory module. With permission from the department it may be substituted with:

EPT 732 OR

EPT 733

EIN 732 is 'n verpligte module. Met toestemming van die departement mag dit vervang word met:

EPT 732 OF

EPT 733

Core modules

  • Module content:

    *This is a compulsory module.

    The aim of this module is to teach students to critically evaluate research literature, including conference papers and journal articles, in order to determine the current state of knowledge in a particular specialist area. It will also provide students with the principles of research to enable them to conduct research and prepare an original project in their particular specialist area.

    View more

  • Module content:

    The integrated circuit (IC) or “chip” is the motor of the present electronic revolution. The ever-increasing impact of electronics is driven mainly by large-scale ICs such as processor and memory chips. The electronic circuit techniques used in these chips can only be understood on a deep level by a study of classical analogue electronics aimed at integrated circuit design for fabrication in CMOS, bipolar and BiCMOS processes. In addition, analog circuit techniques perform an essential role in the interfaces between the “real world” and digital systems. Examples are: voltage references, amplifiers, filters, level-converters, buffers. Important topics in this respect are feedback and stability theory as specialized for electronic circuits. The course includes: IC fabrication technology, models for IC transistors, transistor current sources and amplifiers, output stages, operational amplifiers, frequency response and stability of feedback amplifiers, nonlinear and computational circuits.

    View more

  • Module content:

    Introduction to radio communication systems, small signal amplifiers, multistage amplifiers, differential amplifiers, network noise, intermodulation distortion, noise factor and sensitivity, frequency selective networks, impedance matching, high frequency amplifiers, broadbanding techniques, AGC, oscillators, phase-locked loops, PLL applications, frequency synthesizers, power amplifiers, modulators and demodulators, frequency mixers.

    View more

  • Module content:

    This module will cover the essential theoretical background of the student’s proposed M Eng topic and include inter alia the following:
    (i) Field definition and descriptions
    (ii) In-depth study into background and theory relevant to the problem to be addressed
    (iii) Problem definition and description
    (iv) Mathematical simulations of the problem

    View more

  • Module content:

    This module will include extensive laboratory experiments to test the principles and possible solutions of the proposed M Eng research project and will include inter alia the following. These will include hardware and/or software experiments:
    (i) Introduction to instrumentation and measuring techniques in general and specifically as applied in the field of research.
    (ii) Structured laboratory work to introduce the specific problem investigated for the research undertaken.
    (iii) Structured laboratory work to test the proposed solution for the problem addressed.
    (iv) Confirmation experiments.

    View more


The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2024. All rights reserved.

COVID-19 Corona Virus South African Resource Portal

To contact the University during the COVID-19 lockdown, please send an email to [email protected]

FAQ's Email Us Virtual Campus Share Cookie Preferences