Programme: MEng Control Engineering

Kindly take note of the disclaimer regarding qualifications and degree names.
Code Faculty
12250232 Faculty of Engineering, Built Environment and Information Technology
Credits Duration
Minimum duration of study: 1 year Total credits: 180

Programme information

  • Unless the Dean, on recommendation of the relevant head of department, decides otherwise, the master's degree is conferred on the basis of examinations of coursework and a mini-dissertation or a dissertation (including an examination on the dissertation).
  • A minimum of 128 credits is required to obtain the MEng degree. Either a mini-dissertation (64 credits) and coursework (64 credits) (for all coursework master's degrees) or a dissertation (128 credits) (for all research master's degrees) is included in the programme.
  • Recognition is not granted for credits acquired during studying for the BEngHons or the BScHons.
  • The curriculum is determined in consultation with the relevant head of department. Any specific module is offered on condition that a minimum number of students are registered for the module, as determined by the relevant head of department and the Dean. Students must consult the relevant head of department in order to compile a meaningful programme, as well as for information on the syllabi of the modules. The various departmental postgraduate brochures should also be consulted.

Admission requirements

Subject to the stipulations of the General Regulations, Reg. G.1.3 and G.54, a BEngHons degree or equivalent qualification is required for admission to the MEng programmes.


Examinations and pass requirements

The stipulations of the relevant Faculty regulations are applicable.

The Dean may, on recommendation of the relevant head of department, exempt a student from the examination on the dissertation.

Guidelines for the preparation and examination of mini-dissertations are available from all departments. The average mark awarded by all the examiners is the final mark, with the pass mark being at least 50%.

Research information

A student must by means of a dissertation or mini-dissertation prove that he or she is capable of planning, instituting and executing a scientific investigation. Unless the Senate, on the recommendation of the supervisor, decides otherwise, a student, before or on submission of a dissertation, must submit proof issued by a recognised academic journal that an article was submitted, to the Head: Student Administration. The draft article should be based on the research that the student has conducted for the dissertation and be approved by the supervisor if the supervisor is not a co-author. The supervisor shall be responsible for ensuring that the paper is taken through all the processes of revision and resubmission, as may be necessary. Conferment of the degree may be made subject to compliance with the stipulations of this regulation.

Pass with distinction

  1. A student who submits a dissertation passes with distinction if an average mark of at least 75% is obtained for the dissertation (and the examination on the dissertation).
  2. A student who completes the master's degree on grounds of coursework and a mini-dissertation, passes with distinction if a weighted average mark of at least 75% is obtained in the first 128 credits obtained for the degree [first 256 credits in the case of the MEng (Engineering Management), MEng (Project Management), MSc (Engineering Management) or the MSc (Project Management)], provided that 64 of these credits are allocated to the mini-dissertation. However, the degree is not awarded with distinction should a student fail any of these modules (excluding modules which have been timeously discontinued). The degree is also not awarded with distinction if a student obtains less than 70% for the mini-dissertation.

The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2024. All rights reserved.

FAQ's Email Us Virtual Campus Share Cookie Preferences