Yearbooks

Thermoflow 310


 
Module code MTV 310
Qualification Undergraduate
Faculty Faculty of Engineering, Built Environment and Information Technology
Module content

Introduction: Liquids and gases, pressure, viscosity, temperature, heat. Introduction to Navier-Stokes and continuity equations. Definitions and properties of fluids, fluid statics, fluid dynamics, Bernoulli equations. Flow measurements. Dimensional analysis: force, drag, Reynolds number, force coefficient, power. Flow in pipes and channels: friction coefficients and Reynolds number, pressure drop; laminar, turbulent and transitional flow. Flow over bodies: drag and lift. Experimental techniques in fluid mechanics. Introduction to basic thermodynamic heat transfer concepts: conduction (steady state and transient heat conduction), extended surfaces, applications.

 

Module credits 16.00
Prerequisites No prerequisites.
Contact time 1 practical per week, 3 lectures per week
Language of tuition Module is presented in English
Department Mechanical and Aeronautical Engineering
Period of presentation Semester 1

The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2024. All rights reserved.

COVID-19 Corona Virus South African Resource Portal

To contact the University during the COVID-19 lockdown, please send an email to [email protected]

FAQ's Email Us Virtual Campus Share Cookie Preferences