Yearbooks

Engineering graphics and design 240


 
Module code JTT 240
Qualification Undergraduate
Faculty Faculty of Education
Module content

This module equips students to understand and teach Engineering graphics and design in the FET-Phase. The focus is on intermediate free hand drawing and instrument drawing techniques contextualised for the Department of Education's curriculum requirements for Isometric drawing and Mechanical drawing conventions. Primary and secondary manufacturing processes including fixed bodies. Descriptive Geometry. Evaluation of drawings and error detection. Practical application of techniques.

Module credits 12.00
NQF Level 06
Prerequisites MGC 110, JTT 120, WTW 134 or WTW 114 or WTW 158
Contact time 2 lectures per week, 2 practicals per week
Language of tuition Module is presented in English
Department Science Mathematics and Technology Education
Period of presentation Semester 2

The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Copyright © University of Pretoria 2024. All rights reserved.

FAQ's Email Us Virtual Campus Share Cookie Preferences