Yearbooks

BACK

Engineering graphics and design 240


 
Module code JTT 240
Qualification Undergraduate
Faculty Faculty of Education
Module content

This module equips students to understand and teach Engineering graphics and design in the FET-Phase. The focus is on intermediate free hand drawing and instrument drawing techniques contextualised for the Department of Education's curriculum requirements for Isometric drawing and Mechanical drawing conventions. Primary and secondary manufacturing processes including fixed bodies. Descriptive Geometry. Evaluation of drawings and error detection. Practical application of techniques.
Module credits 12.00
Prerequisites MGC 110, JTT 120, WTW 134
Contact time 2 practicals per week, 2 lectures per week
Language of tuition Double Medium
Academic organisation Science, Maths + Techno Ed
Period of presentation Semester 2
The information published here is subject to change and may be amended after the publication of this information. The General Regulations (G Regulations) apply to all faculties of the University of Pretoria. It is expected of students to familiarise themselves well with these regulations as well as with the information contained in the General Rules section. Ignorance concerning these regulations and rules will not be accepted as an excuse for any transgression.

Postal Address:
University of Pretoria
Private Bag x 20
Hatfield
0028

Location:
GIBS | Groenkloof | Hatfield
Hillcrest | Mamelodi | Onderstepoort | Prinshof

Student Service Centre (for Contact students):
Contact Centre - Telephone: 012 420 3111
Contact Centre - Email: [email protected]

UPOnline Call Centre (for Online Students):
Call Centre - Email: [email protected]

Get Social With Us

Download the UP Mobile App

Copyright © University of Pretoria 2024. All rights reserved.

Careers@UP | Tenders@UP | Ethics Hotline | PAIA Manual | Privacy Notices | Website Privacy Notice | Disclaimer | Terms of use

FAQ's Email Us Virtual Campus Share Cookie Preferences